Ups Module Pin Assignment Table; Table 3-1: Ups Module Pin Assignment And Function - Gamatronic POWER PLUS Technical Manual

Gamatronic Electronic Industries Ltd.

UPS MODULE PIN ASSIGNMENT TABLE

3.1.3
THE DATA PROVIDED BELOW IS FOR INFORMATION ONLY.
DO NOT ATTEMPT TO MAKE ANY CONNECTIONS.
Input Connector
4 = (-425V) 6 = (-425V)
14 = T phase 16 = T phase
24 = R phase 26 = Neutral
Output Connector
4 = OUT3 (T) 6 = OUT3 (T)
14 = OUT1 (R) 16 = N.C.
24 = Neutral 26 = Neutral
Control Connector
"a" Column
1 = System Controller Com
2 = Dry2_opto_E
3 = Dry2_opto_C
4 = N.C.
5 = N.C.
6 = DRY 0
7 = DRY 1
8 = +12V BUS
9 = Force B/P Inv
10 = Common BUS
11 = Dry 2
12 = Reference Frequency
13 = SPI Select
14 = MIS 0
15 = MIS 1
16 = SPI_SCK
Power+ Technical Guide
WARNING

Table 3-1: UPS module pin assignment and function

8 = (-425V)
18 = S phase
28 = (+425V)
8 = OUT2 (S)
18 = N.C.
28 = N.C.
"b" Column
1 = Controller TX
2 = N.C.
3 = N.C.
4 = N.C.
5 = N.C.
6 = UPS OFF
7 = CAN BUS
8 = Stand Alone
9 = AC on INV 1
10 = Common BUS
11 = Device Address (#3)
12 = Device Address (#2)
13 = Device Address (#1)
14 = Device Address (#0)
15 = +12V BUS
16 = Address Common
10 = Neutral 12 = Neutral
20 = S phase 22 = R phase
30 = (+425V) 32 = (+425V)
10 = OUT2 (S) 12 = OUT1 (R)
20 = N.C. 22 = Neutral
30 = N.C. 32 = N.C.
"c" Column
1 = Controller RX
2 = N.C.
3 = N.C.
4 = N.C.
5 = N.C.
6 = Vout_Sum
7 = WANT
8 = Vcc (+5V)
9 = Address Com.
10 = Common BUS
11 = PLL DATA BUS
12 = PLL SYNC BUS
13 = Sharing BUS (S)
14 = Sharing BUS (R)
15 = Sharing BUS (T)
16 = +12V BUS
25