Table 5-3: Log Messages "Description" Field - Gamatronic POWER PLUS Technical Manual

Gamatronic Electronic Industries Ltd.
Alarm
Message
#
01 UPSMAJ
02 UPSMIN
03 ------
04 ------
05 LOADBP
06 VIBRA_
07 OVTEMP
08 OUTFLT
09 BAT-HI
10 ------
11 BATEND
12 BATLOW
13 STSWRN
14 E.P.O.
15 EQ-HST
16 BATFLT
17 USER-1
18 USER-2
19 USER-3
20 AC-BRN
21 ACIN_H
22 ACFAIL
23 STSWCM
24 SLFFLT
25 BAT-CB
26 CURSHR
27 UPSOUT
28 UPSHDN
29 OVLOAD
30 UPS-CM
31 STRTUP
32 ------
Power+ Technical Guide
Table 5-3
: Log Messages "description" field
Explanation
More than 1 UPS Module is sending an alarm or fault warning.
Single UPS Module is sending an alarm or fault warning.
N.A.
N.A.
Load is now running on bypass. "Data" field holds the STSW transfer
code – see Table 5-4 for interpretation of the STSW transfer code.
Alarm(s) vibrating. Alarm is frequently raised and lowered. Ignore to avoid
loading the log filling up.
Excess temperature.
No ac output to load.
Excessive battery voltage.
N.A.
End of battery backup. Battery is discharged to shutdown limit.
Low battery voltage.
Static Switch Warning or alarm.
Emergency Power Off is active.
Battery is currently charging in equalizing mode, dc voltage is temporarily
increased.
Batteries failed last test.
User 1 input open.
User 2 input open
User 3 input open.
Input ac supply brown-out.
Ac input excessive.
Ac input failure.
Static Switch does not respond.
Last controller self-test failed.
Battery circuit breaker open.
Current Sharing fault, load current is not equally divided between
modules.
Fault (no current) in 1 or more output stage.
UPS shutdown by EPO, Battery Discharge, ON/OFF pressed.
Load current is high.
One or more UPS's not responding.
Startup time-stamp.
N.A.
63