Dip Switch Settings Of The Ups Modules - Gamatronic POWER PLUS Technical Manual

4.6

DIP SWITCH SETTINGS OF THE UPS MODULES

Dip switch #1(in
operation in stand-alone mode.
Dip switch #2(in middle) should be ON(LEFT) for 60Hz and OFF(RIGHT) for 50Hz
inverter operation.
Dip switch #3(in top) should be ON(LEFT) for 3 phase and OFF(RIGHT) for 1 phase
inverter output.
NOTE: All settings must be identical on each of the modules in a single (non-parallel) system.
The location of the dip switches on a UPS module is shown in the picture below.
54
) should always be OFF(RIGHT), designed for manual master
bottom
Gamatronic Electronic Industries Ltd.
Power+ Technical Guide