System Definition - Fuji Electric MICREX-SX series SPF User Manual

Section 2 System Configuration

2-2 System definition

When using SPF series, you need to register the actual unit configuration in a project.
<Example of system configuration>
24V OUT
+ S/S
400mA
TX
G RX
T N
+
TX
G RX
IN AC100~240V
T N L N
C0 Y0
NA0LA-RS5
Expansion left side unit
Type: NA0LA-RS5
<System configuration definition tree window>
The system configuration definition tree for the above system configuration is shown below.
<Rules for defining system configuration>
• For system definition, the unit on the right of the main unit is registered just below the main unit.
As for the unit station Nos. of units, the main unit is always assigned "0" (zero), and numbers beginning with 1 (one) are
assigned to expansion right side units, in their connected order.
• The front board is connected on the front of the main unit and registered below the expansion right side unit in the configuration
definition tree. The unit station No. is fixed to "100."
• The expansion left side unit is connected to the left of the main unit and registered at the lowermost location in the configuration
definition tree. The unit station No. is fixed to "200."
Front board
Type: NA3LA-RS1
X0 X2 X4 X6 X8 X10 X12 X14 X16 X18 X20
X1 X3 X5 X7 X9 X11 X13 X15 X17 X19
IN (X)
PWR/
BAT
RUN/
MEM
ALM
OUT (Y)
PORT0
Y1 Y2 Y4 Y5 Y6 Y8 Y10 Y12 Y14
C2 Y3 C4 C6 Y7 C8 Y9 Y11 C12 Y13
Main unit
Type: NA0PA40T-31C
X22 C0 Y1 C2 C4 Y5 Y7
X21 X23 Y0 Y2 Y3 Y4 Y6
NA0E16T-0
Y8 Y10 Y11 Y12 Y14
C8 Y9 C10 C12 Y13 Y15
Y15
Expansion right side unit
Type: NA0E16T-0
2-7
24V IN O0+ O1+
AG O0- O1-
NA0AW06-MR
I0+ I1+ I2+ I3+
I0- I1- I2- I3-
Expansion right side unit
Type: NA0AX06-MR