Table of Contents
Advertisement
Installation
Mounting the Optional Remote Panel
To mount the remote panel:
1. Choose a location for the remote panel that is within
2. Use the mounting template provided with the Remote
3. Connect the RJ-12 connector to the remote panel and
4. Once the Truecharge™ 2 Battery Charger is mounted,
Note:
panel uses six conductors. The sensor cable for the BTS on the
other hand, uses four conductors – an RJ-11 cable.
2–26
This guide for use by qualified installers only
Elcodis.com
electronic components distributor
15 m (50 ft.) from the charger. Use only the
six-conductor communications cable (RJ-12) that came
with the remote panel.
Panel to predrill mounting holes.
Take care that there is nothing behind the surface for you
to damage such as other cables or pipes.
route it to the charger. Be careful not to damage the
connector locking tab when routing the cable. You can
use some tape to protect the locking tab from catching on
something and breaking off when routing the cable.
plug the other RJ-12 connector into the Remote port on
the rear panel of the Truecharge™ 2 Battery Charger.
The RJ-12 communications cable used for the remote
975-0402-01-01
Advertisement
Table of Contents
