D-Link xStack DGS-3426 Cli Manual page 50

Example usage:
To download a configuration file:
DGS-3400:4#download configuration 10.48.74.121 c:\cfg\setting.txt
Command: download configuration 10.48.74.121 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
DGS-3450:4#
DGS-3450:4##-------------------------------------------------------------------------------
DGS-3450:4##
DGS-3450:4##
DGS-3450:4##
DGS-3450:4##
DGS-3450:4##
DGS-3450:4##-------------------------------------------------------------------------------
DGS-3450:4#
DGS-3450:4## STACK
DGS-3450:4#
DGS-3450:4#
DGS-3450:4## BASIC
DGS-3450:4#
DGS-3450:4#config serial_port auto_logout never
Command: config serial_port auto_logout never
The download configuration command will initiate the loading of the various settings in the order listed in the configuration file.
When the file has been successfully loaded the message "End of configuration file for DGS-3400" appears followed by the
command prompt.
DGS-3400:4# # ROUTE
DGS-3400:4#
DGS-3400:4# create iproute default 172.18.212.253 1
Command: create iproute default 172.18.212.253 1
Success.
DGS-3400:4#
DGS-3400:4# #-------------------------------------------------------------------
DGS-3400:4# #
DGS-3400:4# #-------------------------------------------------------------------
DGS-3400:4# #
config configuration
Purpose
Syntax
Description
Parameters
Restrictions
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3450 Gigabit Ethernet Switch
Firmware: Build 1.20-B15
Copyright(C) 2004-2007 D-Link Corporation. All rights reserved.
End of configuration file for DGS-3450
Used to designate a stored configuration file section ID as a boot up
configuration, active configuration or to delete the configuration file.
config_id 1-2> [boot_up | delete | active]
This command is used to configure the section ID index of a stored
configuration as the boot up or active configuration.Or to delete the contents of
the specified configuration section.
config_id – Specifies the section being configured or deleted.
delete – Entering ths will delete the contents of the speified section.
boot_up – Entering specifies the configuration section as a boot up section.
active – Entering specifies the configuration section as an active section.
Only administrator-level users can issue this command.
Configuration
47