D-Link xStack DGS-3426 Cli Manual page 161

create access_profile (ipv6)
Parameters
Restrictions
Example usage:
To create an access profile based on IPv6 classification:
DGS-3400:4#create access_profile profile_id 4 ipv6 class flowlabel
Command: create access_profile profile_id 4 ipv6 class flowlabel
Success.
DGS-3400:4#
config access_profile profile_id (ipv6)
Purpose
Syntax
Description
Parameters
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
profile_id <value 1-6> - Specifies an index number between 1 and 6 that will
identify the access profile being created with this command.
ipv6 – Denotes that IPv6 packets will be examined by the Switch for forwarding
or filtering based on the rules configured in the config access_profile
command for IPv6. IPv6 packets may be identified by the following:
class – Entering this parameter will instruct the Switch to examine the
•
class field of the IPv6 header. This class field is a part of the packet
header that is similar to the Type of Service (ToS) or Precedence bits
field in IPv4.
flowlabel – Entering this parameter will instruct the Switch to examine the
•
flow label field of the IPv6 header. This flow label field is used by a source
to label sequences of packets such as non-default quality of service or
real time service packets.
source_ipv6_mask <ipv6mask> - Specifies an IP address mask for the
•
source IPv6 address.
destination_ipv6_mask <ipv6mask> - Specifies an IP address mask for
•
the destination IPv6 address.
Only administrator-level users can issue this command.
Used to configure the IPv6 access profile on the Switch and to define specific values for
the rules that will be used to by the Switch to determine if a given packet should be
forwarded or filtered. Masks entered using the create access_profile command will be
combined, using a logical AND operational method, with the values the Switch finds in
the specified frame header fields.
config access_profile profile_id <value 1-6> add access_id [auto_assign | <value
1-128>] ipv6 {class <value 0-255> | flowlabel <hex 0x0-0xfffff> | source_ipv6
<ipv6addr> | destionation_ipv6 <ipv6addr>} port [<portlist> | all] [permit {priority
<value 0-7> {replace_priority} | deny | rx_rate [no_limit | value 1-156249]]] | delete
access_id <value 1-128>]
This command is used to define the rules used by the Switch to either filter or forward
packets based on the IPv6 part of each packet header.
profile_id <value 1-6> - Enter an integer between 1 and 6 that is used to identify the
access profile that will be configured with this command. This value is assigned to the
access profile when it is created with the create access_profile command. The lower
the profile ID, the higher the priority the rule will be given.
add access_id <value 1-128> - Adds an additional rule to the above specified access
profile. The value specifies the relative priority of the additional rule. Up to 128 different
rules may be configured for the IPv6 access profile.
•
auto_assign – Choose this parameter to configure the Switch to automatically
assign a numerical value (between 1 and 65535) for the rule being configured.
158