Jumbo Frame Commands - D-Link xStack DGS-3426 Cli Manual

Certain switches can support jumbo frames (frames larger than the standard Ethernet frame size of 1518 bytes). To transmit
frames of up to 9K (and 9216 bytes tagged), the user can increase the maximum transmission unit (MTU) size from the default of
1536 by enabling the Jumbo Frame command.
The jumbo frame commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
enable jumbo_frame
disable jumbo_frame
show jumbo_frame
Each command is listed, in detail, in the following sections.
enable jumbo_frame
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the jumbo frame function on the Switch:
disable jumbo_frame
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the jumbo frame function on the Switch:
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Parameters
Used to enable the jumbo frame function on the Switch.
enable jumbo_frame
This command will allow ethernet frames larger than 1536 bytes
to be processed by the Switch. The maximum size of the jumbo
frame may not exceed 9k.
None.
Only administrator-level users can issue this command.
DGS-3400:4#enable jumbo_frame
Command: enable jumbo_frame
Success.
DGS-3400:4#
Used to disable the jumbo frame function on the Switch.
disable jumbo_frame
This command will disable the jumbo frame function on the
Switch.
None.
Only administrator-level users can issue this command.
J
UMBO
225
F C
RAME OMMANDS
33