D-Link xStack DGS-3426 Cli Manual page 115

Example usage:
To display Link Aggregation configuration:
config lacp_port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure LACP port mode settings:
DGS-3400:4#config lacp_port 1-12 mode active
Command: config lacp_port 1-12 mode active
Success.
DGS-3400:4#
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source-dest
Group ID : 1
Type : LACP
Master Port : 50
Member Port : 49-50
Active Port :
Status : Disabled
Flooding Port : 0
DGS-3400:4#
Used to configure settings for LACP compliant ports.
config lacp_port <portlist> mode [active | passive]
This command is used to configure ports that have been previously
designated as LACP ports (see create link_aggregation).
<portlist> − Specifies a port or range of ports to be configured.
mode – Select the mode to determine if LACP ports will process
LACP control frames.
•
active – Active LACP ports are capable of processing
and sending LACP control frames. This allows LACP
compliant devices to negotiate the aggregated link so the
group may be changed dynamically as needs require. In
order to utilize the ability to change an aggregated port
group, that is, to add or subtract ports from the group, at
least one of the participating devices must designate
LACP ports as active. Both devices must support LACP.
•
passive – LACP ports that are designated as passive
cannot process LACP control frames. In order to allow
the linked port group to negotiate adjustments and make
changes dynamically, at one end of the connection must
have "active" LACP ports (see above).
Only administrator-level users can issue this command.
112