D-Link xStack DGS-3426 Cli Manual page 232

disable sim
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable SIM on the Switch:
show sim
Purpose
Syntax
Description
Parameters
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#enable sim
Command: enable sim
Success.
DGS-3400:4#
Used to disable Single IP Management (SIM) on the Switch
disable sim
This command will disable SIM globally on the Switch.
None.
Only administrator-level users can issue this command.
DGS-3400:4#disable sim
Command: disable sim
Success.
DGS-3400:4#
Used to view the current information regarding the SIM group on the Switch.
show sim {[candidates {<candidate_id 1-100>} | members {<member_id 1-32>}
| group {commander_mac <macaddr>}] | neighbor]}
This command will display the current information regarding the SIM group on the
Switch, including the following:
SIM Version - Displays the current Single IP Management version on the Switch.
Firmware Version - Displays the current Firmware version on the Switch.
Device Name - Displays the user-defined device name on the Switch.
MAC Address - Displays the MAC Address of the Switch.
Capabilities – Displays the type of switch, be it Layer 2 (L2) or Layer 3 (L3).
Platform – Switch Description including name and model number.
SIM State –Displays the current Single IP Management State of the Switch,
whether it be enabled or disabled.
Role State – Displays the current role the Switch is taking, including Commander,
Member or Candidate. A Stand-alone switch will always have the commander role.
Discovery Interval - Time in seconds the Switch will send discovery packets out
over the network.
Hold time – Displays the time in seconds the Switch will hold discovery results
before dropping it or utilizing it.
candidates <candidate_id 1-100> - Entering this parameter will display information
concerning candidates of the SIM group. To view a specific candidate, include that
candidate's ID number, listed from 1 to 32.
members <member_id 1-32> - Entering this parameter will display information
concerning members of the SIM group. To view a specific member, include that
member's id number, listed from 1 to 32.
group {commander_mac <macaddr>} - Entering this parameter will display
229