D-Link xStack DGS-3426 Cli Manual page 218

DGS-3400:4# config ssh server maxsession 2 contimeout 300 authfail 2
Command: config ssh server maxsession 2 contimeout 300 authfail 2
Success.
DGS-3400:4#
show ssh server
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To display the SSH server:
config ssh user
Purpose
Syntax
Description
Parameters
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to display the SSH server setting.
show ssh server
This command allows you to display the current SSH server setting.
None.
None.
DGS-3400:4# show ssh server
Command: show ssh server
The SSH server configuration
SSH Server Status
Max Session
Connection timeout
Authfail attempts
Rekey timeout
Listened Port Number
DGS-3400:4#
Used to configure the SSH user.
config ssh user <username> authmode [hostbased [hostname
<domain_name> | hostname_IP <domain_name> <ipaddr>] |
password | publickey]
This command allows you to configure the SSH user authentication
method.
<username> - Enter a username of no more than 15 characters to
identify the SSH user.
authmode – Specifies the authentication mode of the SSH user
wishing to log on to the Switch. The administrator may choose
between:
hostbased – This parameter should be chosen if the user wishes to
use a remote SSH server for authentication purposes. Choosing this
parameter requires the user to input the following information to
identify the SSH user.
hostname <domain_name> - Enter an alphanumeric string of up to
32 characters identifying the remote SSH user.
hostname_IP <domain_name> <ipaddr> - Enter the hostname and
the corresponding IP address of the SSH user.
password – This parameter should be chosen if the user wishes to
use an administrator defined password for authentication. Upon
entry of this command, the Switch will prompt the user for a
: Disabled
: 8
: 120
: 2
: never
: 22
215