D-Link xStack DGS-3426 Cli Manual page 143

DGS-3400:4#show 802.1x auth_state
Command: show 802.1x auth_state
Port number : 1
Index MAC Address
------ -------------------
1 00-08-02-4E-DA-FA
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
CTRL+C ESC q
config 802.1x auth_mode
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1x authentication by MAC address:
DGS-3400:4#config 802.1x auth_mode mac_based
Command: config 802.1x auth_mode mac_based
Success.
DGS-3400:4#
config 802.1x capability ports
Purpose
Syntax
Description
Parameters
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Auth PAE State
-----------------------
Authenticated
Quit SPACE n Next Page
Used to configure the 802.1x authentication mode on the Switch.
config 802.1x auth_mode {port_based | mac_based]
The config 802.1x authentication mode command is used to enable either
the port-based or MAC-based 802.1x authentication feature on the Switch.
[port_based | mac_based] − The Switch allows you to authenticate 802.1x by
either port or MAC address.
Only administrator-level users can issue this command.
Used to configure the 802.1x capability of a range of ports on the
Switch.
config 802.1x capability ports [<portlist> | all] [authenticator |
none]
The config 802.1x command has four capabilities that can be set for
each port. Authenticator, Supplicant, Authenticator and Supplicant,
and None.
<portlist> − Specifies a port or range of ports to be configured.
Backend State
---------------------
Idle
Enter Next Entry a All
140
Port Status
-----------------
Authorized