D-Link xStack DGS-3426 Cli Manual page 19

disable clipaging
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable pausing of the screen display when show command output reaches the end of the page:
enable telnet
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable Telnet and configure port number:
disable telnet
Purpose
Syntax
Description
Parameters
Restrictions
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to disable the pausing of the console screen scrolling at the
end of each page when the show command displays more than one
screen of information.
disable clipaging
This command is used to disable the pausing of the console screen
at the end of each page when the show command would display
more than one screen of information.
None.
Only administrator-level users can issue this command.
DGS-3400:4#disable clipaging
Command: disable clipaging
Success.
DGS-3400:4#
Used to enable communication with and management of the Switch
using the Telnet protocol.
enable telnet <tcp_port_number 1-65535>
This command is used to enable the Telnet protocol on the Switch.
The user can specify the TCP or UDP port number the Switch will
use to listen for Telnet requests.
<tcp_port_number 1-65535> − The TCP port number. TCP ports
are numbered between 1 and 65535. The "well-known" TCP port for
the Telnet protocol is 23.
Only administrator-level users can issue this command.
DGS-3400:4#enable telnet 23
Command: enable telnet 23
Success.
DGS-3400:4#
Used to disable the Telnet protocol on the Switch.
disable telnet
This command is used to disable the Telnet protocol on the Switch.
None.
Only administrator-level users can issue this command.
16