D-Link xStack DGS-3426 Cli Manual page 18

config serial_port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure baud rate:
enable clipaging
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable pausing of the screen display when the show command output reaches the end of the page:
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Used to configure the serial port.
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] |
auto_logout [never | 2_minutes | 5_minutes | 10_minutes |
15_minutes]}
This command is used to configure the serial port's baud rate and auto
logout settings.
baud_rate [9600 | 19200 | 38400 | 115200]− The serial bit rate that will be
used to communicate with the management host. There are four options:
9600, 19200, 38400, 115200.
never − No time limit on the length of time the console can be open with
no user input.
2_minutes − The console will log out the current user if there is no user
input for 2 minutes.
5_minutes − The console will log out the current user if there is no user
input for 5 minutes.
10_minutes − The console will log out the current user if there is no user
input for 10 minutes.
15_minutes − The console will log out the current user if there is no user
input for 15 minutes.
Only administrator-level users can issue this command.
DGS-3400:4#config serial_port baud_rate 115200
Command: config serial_port baud_rate 115200
Success.
DGS-3400:4#
Used to pause the scrolling of the console screen when the show
command displays more than one page.
enable clipaging
This command is used when issuing the show command which
causes the console screen to rapidly scroll through several pages.
This command will cause the console to pause at the end of each
page. The default setting is enabled.
None.
Only administrator-level users can issue this command.
DGS-3400:4#enable clipaging
Command: enable clipaging
Success.
DGS-3400:4#
15