Modification Of Zero Offset Values; Change Of Measurement Units; Return To The Tool Offset Table; Complete Deletion Of Tool Offsets Or Zero Table - Fagor 8025 GP Operating Manual

3.8.6.3. Modification of zero offset values

Same as 3.8.4.

3.8.6.4. Change of measurement units

Same as 3.8.5.

3.8.7. Return to the tool offset table

When the zero offset table is being displayed, the tool table can be recovered by pressing
T.

3.8.8. Complete deletion of tool offsets or zero table

- Key in K,J,I.
- Press ENTER.
The displayed table is completely erased.
In mode 8 (G53/G59 tool table), press RESET to revert the CNC to initial conditions.
3.9.

MODE 9: SPECIAL MODES

The information on this section is in the INSTALLATION AND START UP
MANUAL.
62 8025/8030 CNC OPERATING MANUAL