Danfoss ECL Comfort 210 Installation Manual page 97

Installation Guide
ECL 485 addr. (master / slave address)
Circuit
This settting is relevant if more controllers are working in the same ECL
Comfort system (connected via the ECL 485 communication bus) and / or
Remote Control Units (ECA 30 / 31) are connected.
0:
The controller works as slave.
The slave receives information about the outdoor
temperature (S1), system time, and signal for DHW
demand in the master.
1... 9:
The controller works as slave.
The slave receives information about the outdoor
temperature (S1), system time, and signal for DHW
demand in the master. The slave sends information
about the desired flow temperature to the master.
10... 14: Reserved.
15:
The ECL 485 communication bus is active.
The controller is master. The master sends information
about the outdoor temperature (S1) and system time.
Connected Remote Control Units (ECA 30 / 31) are
powered.
The ECL Comfort controllers can be connected via the ECL 485
communication bus to perform a larger system (the ECL 485
communication bus can connect to max. 16 devices).
Each slave must be configured with its own address (1 ... 9).
However, more slaves can have the address 0 if they only have to
receive information about outdoor temperature and system time
(listeners).
7.7.4 Language
Language
Circuit
Choose your language.
Danfoss District Energy
ECL Comfort 210, application A230
2048
Setting range Factory setting
0 ... 15
2050
Setting range Factory setting
English / 'Local' English
The total cable length of max. 200 m (all devices incl. the internal ECL
15
485 communication bus) should not be exceeded.
Cable lengths of more than 200 m may cause noise sensibility (EMC).
Local language is selected during installation. If you want to change to
another local language, the application must be reinstalled. However,
it is always possible to change between the local language and English.
VI.LG.H1.02 DEN-SMT/DK 97