Danfoss ECL Comfort 210 Installation Manual page 86

Installation Guide
P cool T (cooling demand)
Circuit
1
When the desired flow temperature is below the set temperature in 'P cool T' ,
the controller automatically switches ON the circulation pump.
5 ... 40: The circulation pump is switched ON when the desired
flow temperature is below the set value.
Standby T
Circuit
1
Set the desired flow temperature for the controller when it is in standby
mode.
5 ... 40: Desired flow temperature at standby.
Ext. input (external override)
Circuit
1
Choose the input for 'Ext. input' (external override). By means of a switch the
controller can be overridden to Comfort or Saving mode.
OFF:
No inputs have been selected for external override.
S1 ... S8: Input selected for external override.
If S1...S6 is chosen as override input, the override switch must have
gold-plated contacts.
If S7 or S8 is chosen as override input, the override switch can be a
standard contact.
See the drawing for a connection example of an override switch
to input S8.
Ext. mode (external override mode)
Circuit
1
Choose external override mode.
The mode override can be activated for saving or comfort mode.
For override, the controller mode must be scheduled mode.
SAVING: The controller is in saving mode when the override
switch is closed.
COMFORT: The controller is in comfort mode when the override
switch is closed.
86 DEN-SMT/DK
ECL Comfort 210, application A230
Setting range Factory setting
5 ... 40 °C
Setting range Factory setting
5 ... 40 °C
Setting range Factory setting
OFF / S1 ... S8
Factory setting
Setting range
COMFORT / SAVING COMFORT
11070
The valve is fully closed as long as the pump is not switched on.
25 °C
11092
30 °C
11141
OFF
Choose only an unused input for override. If an already used input is
applied for override, the functionality of this input is also neglected.
See also 'Ext. mode' .
11142
See also 'Ext. input' .
VI.LG.H1.02
Danfoss District Energy