Installation Checklist - ABB DCS880 series Hardware Manual

Installation checklist

Check the mechanical and electrical installation of the drive before start-up. Go
through the checklist below together with another person. Read the
instructions
MECHANICAL INSTALLATION
The ambient operating conditions are allowed (see
The unit is mounted properly on a vertical non-flammable wall (see
The cooling air will flow freely (see
an enclosure)
The motor and the driven equipment are ready for start
All screen terminals are checked for tightness (see
All cable connections are seated properly (see
ELECTRICAL INSTALLATION (see
The converter modules are grounded properly
The mains voltage matches the converter module's nominal input voltage
The mains (input power) connections at U1, V1 and W1 (L1, L2 and L3) and their tightening
torques are OK
The appropriate mains fuses and disconnector are installed
The drive connections at C1, D1 and F+, F- and their tightening torques are OK
Motor cable routing (armature and exitation) is OK
Check that the screens are properly installed at the motor and the drive cabinet
The motor connections L+, L-, F+ and F- and their tightening torques are OK
The control connections are OK
If a pulse encoder is used, check the encoder cables and correct direction of rotation
PTC, klixon cables: Check that the connections are appropriate for the type of sensor used in
the motor
Check the Safe Torque Off (STO) circuit for proper function
Check the prevention of unexpected start-up (on inhibit, coast stop) circuit for proper function
Proper function of E-stop circuit and relay
Cooling fan power wiring connected
The external control connections inside the drive are OK
Converter, motor connection box and other covers are in place
3ADW000462R0101 DCS880 Hardware Manual e a
on the first pages of this manual before you work on the unit.
Cabinet
Planning the electrical
3ADW000462R0101 DCS880 Hardware Manual e a
Environmental Conditions, Current ratings)
installation, Mounting the converter module inside
Connecting the signal and control
Connecting the signal and control
installation,
Safety
Mechanical installation)
cables)
cables)
Electrical installation)
Installation checklist
45