Roland MDX-50 User Manual page 88

An Error Message Appears
Error message
Error num-
ber
(built-in panel)
The machine's inter-
1047-**** nal memory cannot
be accessed.
Detected an emer-
gency stop signal
1048-0000
from the external
input terminal.
An unknown error
****_**** occurred.
86
7. Troubleshooting
Cause
-
-
-
Action/procedure
Select "OK" on the built-in panel, and then press
[ENTER]. This will clear the error.
* Cutting data can be sent. However, you must not
disconnect the USB cable during cutting.
If the error occurs again after perform the above operations
Contact your authorized Roland DG Corp. dealer
Check the status of the device connected to
1 expansion port 2.
"Setup Guide"
Restart the machine.
2
Restart the machine.
If the error occurs again after perform the above operations
Contact your authorized Roland DG Corp. dealer.