Roland MDX-50 User Manual page 87

Error message
Error num-
ber
(built-in panel)
The automatic cor-
103B-0000 rection is not yet fin-
ished.
You cannot set the
origin with the ma-
-
chine coordinate
system.
The automatic set-
1044-0000
ting of Z0 failed.
The error occurred
1045-**** during synchronizing
the control board.
The combination
of firmware version
1046-**** of the main board
and the sub board
is invalid.
Cause
Cutting may have been
started without first per-
forming automatic cor-
rection.
The firmware version may
not correspond to the
VPanel version.
-
The following are likely
reasons.
• The Z0 sensor has not
been connected.
• The Z0 sensor surface is
dirty.
• The detection pin surface
is dirty.
An error occurred during
control board synchroni-
zation.
The combination of main
board and sub board firm-
ware versions is invalid.
An Error Message Appears
Action/procedure
Select "OK" on the built-in panel, and then
1
press [ENTER]. This will clear the error.
2 Perform automatic correction until com-
pletion.
P. 35 "Correcting the Cutting Machine (Auto-
matic Correction)"
1 Update both the firmware and VPanel to their
latest versions.
"Setup Guide"
2 Perform automatic correction until com-
pletion.
P. 35 "Correcting the Cutting Machine (Auto-
matic Correction)"
Procedure (RML Mode)
1 Press [COORD. SYSTEM] to switch to the user
coordinate system.
2 Set the origin again.
Procedure (NC Mode)
Press [COORD. SYSTEM] to switch to the
coordinate system for which you want to set
the origin.
Select "OK" on the built-in panel, and then
1
press [ENTER]. This will clear the error.
Connect the Z0 sensor cable again.
2
Position the detection pin directly over the
3
Z0 sensor.
4 Use the [Z0 SENSE] button to automatically
set the Z user origin again.
Restart the machine.
If the error occurs again after perform the above operations
Contact your authorized Roland DG Corp. dealer.
Update the firmware to its latest version.
7. Troubleshooting
85