Roland MDX-50 User Manual page 28

3. Cutting
E
Turn the hand-wheel to select "Yes."
F
Press [ENTER].
The tool bur slowly descends to touch the sensor. The tool bur then ascends. When it stops moving, the setting
is complete.
Can cel i ng th e de t e c t i on o pe r a t i on
If you want to stop the tool bur while it is descending, press [ENTER].
4.
Remove the Z0 sensor and the detection pin.
A
Return the detection pin.
1 Press [MENU] several times to select "ATC Tool Bur."
2 Turn the hand-wheel to select "Return Tool Bur."
3 Press [ENTER].
The machine operates, and the detection pin is returned. Press [MENU] several times to return to the top window.
B
Remove the Z0 sensor.
1 Open the front cover.
2 Remove the Z0 sensor.
3 Attach the protective "Z0 SENSOR/ROTARY" cap.
CAU TIO N
Remove the cable while holding the part shown
in the following figure. If you hold a part other
than that shown in the figure, the connecting
parts may be damaged.
Position to hold
C
Close the front cover.
D
Press [ENTER].
26
3. Cutting (One Side Cutting)