Test Cut" Dialog Box - Roland MDX-50 User Manual

"Test cut" Dialog Box

Use this dialog box to perform test cutting for the specified NC code.
- [Test]
File
Code
Coordinate System
Display
Override
Canceled
End Test
This displays a list of the files and the test progress. The file currently being tested is
highlighted and is displayed to the left of the file name.
of the names of files that have already been tested.
This displays the NC code written in the file. The line (block) that is currently being
executed is highlighted.
Execute the next block, and then pause the operation.
During execution, this button as well as the
Pause the cutting machine. Click this button again to resume operation.
This button is only enabled during operation.
Perform normal operation (a run) without pausing after each block. However, operation
will be paused in blocks that contain the "M01" command. To resume operation, click
or . During a run, this button is disabled.
Perform operations at the fastest speed at all times (a dry run). However, operation
will be paused in blocks that contain the "M01" command. To resume operation, click
[Run] or [Dry Run].
During a dry run, this button is disabled.
Select the coordinate system of the coordinate values displayed on the built-in panel
and on the top window.
"G55" to "G59," "EXOFS"
Adjust the overrides.
Feeding Adjust the override of the feeding speed (during cutting).
speed Each time you click one of the arrow buttons, the value decreases or
increases by 10.
Range: 10 to 200 [%]
Spindle Adjust the override of the spindle rotating speed.
rotation Each time you click one of the arrow buttons, the value decreases or
increases by 5.
Range: 25 to 200 [%]
Cancels (or continues) cutting. The "Paused" dialog box appears.
Clear the test cutting mode and close this dialog box.
The remaining blocks are output normally, and the machine continues to operate.
If you have used [Canceled] to cancel operations, the machine switches to standby.
is displayed to the left
and buttons are disabled.
6. VPanel Operation (Practical Use)
"Cut" Dialog Box
67