Step 3 : Mounting The Workpiece On The Machine - Roland MDX-50 User Manual

C
Check that there is no cutting waste or other debris in the stocker, and then load the tool bur.
Firmly insert the tool bur as far as possible. Up to 6 tool burs can be loaded.
M E M O
If you register the tool bur information in VPanel, you can record the work time of the actually used tool burs
and check the estimated replacement periods.
" P.65 "Registering Tool Bur Information"

Step 3 : Mounting the Workpiece on the Machine

Procedure
A
Affix double-stick tape to the workpiece.
If necessary, affix a scrap board to the workpiece, and then mount it on the machine.
B
Mount the workpiece on the table.
C
Close the front cover.
D
Press [ENTER].
Double-stick tape
Workpiece bottom surface
3. Cutting (One Side Cutting)
3. Cutting
21