Daily Maintenance; Cleaning After Cutting Finishes - Roland MDX-50 User Manual

Daily Maintenance

Cleaning after Cutting Finishes

After cutting finishes, clean the inside of the machine using a commercially available brush or dust collector. Also clean the
tool bur.
WARNING
1.
Clean the inside of the machine.
A
Remove the workpiece that has been cut and return the tool bur to the ATC magazine.
If the material cannot be peeled off cleanly, use a tool such as a spatula to remove it.
B
Move the spindle and the table to the cleaning position.
" P. 42 "Quickly Moving to a Specific Position"
C
Clean the inside of the machine.
Brush off the cutting waste that has fallen on the X- and Z-shafts and around the table using a commercially
available brush.
I m p or t a nt
Do not inadvertently touch the computer or the operating panel while performing this
task.
Unintended operation of the machine may lead to you being caught in the machine.
Carefully clean off any cutting waste in the area around the magazine, as
cutting waste affixing to this area may affect the cutting results.
Ventilation port
Remove any cutting waste that is present
on the surface of the spindle head. If
cutting waste remains in the vicinity of the
ventilation port for a long period of time,
the blower's functionality may decrease.
Cutting waste
also collects be-
hind the spindle
head. Check
that no cutting
waste has col-
lected here.
31
4. Maintenance