Roland MDX-50 User Manual page 27

B
Place the Z0 sensor in the position where you want to set the Z origin.
Orient the Z0 sensor so that its side without screw threads faces upward.
The Z0 sensor is 15
mm (0.59 in.) thick.
C
Close the front cover.
D
Press [ENTER].
3.
Set the Z0 origin.
A
Select and retain the detection pin.
1
Press [MENU] several times to select "ATC Tool Bur."
2 Turn the hand-wheel to select "Tool Bur 6."
3 Press [ENTER].
The machine operates, and the detection pin is retained. Press [MENU] several times to return to the top window.
B
Move the detection pin above the Z0 sensor.
" P.41 "Using Hand-wheel Operations to Move the Tool Bur (Hand-wheel Feed)"
C
Press [COORD. SYSTEM] several times to select the coordinate system.
If you select [MACHINE], you will not be able to set the origins.
D
Press [Z0 SENSE].
The screen shown in the following figure is displayed.
Workpiece
ME MO
The screen shown in the figure on the left is not
displayed when:
• The tool bur is not retained.
• The spindle is rotating.
3. Cutting (One Side Cutting)
3. Cutting
25