Cutter Registration" Dialog Box - Roland MDX-50 User Manual

"Cutter management" Dialog Box

"Cutter registration" Dialog Box

You can change a tool bur's registration information in order to change the work time or the replacement time.
- [Cutter registration]
Tool bur list
Tool bur infor-
mation
Add cutter
Copy cutter
Remove cutter
64
6. VPanel Operation (Practical Use)
Displays the names, work times, and replacement times of the registered tool burs.
Cutter name Displays the tool bur name. You can also set the name.
Work time Displays the tool bur work time. You can also set the work time.
R e p l a c e m e n t Displays the tool bur replacement time. You can also set the re-
time placement time. If you set this to "0," the warning message when
the replacement time is reached will not be displayed.
Initial value: 0
Reset Reset the work time of the tool bur to "0."
Save You can edit the name, work time, and replacement time of the
tool bur selected in the list. Click [Save] to save the edited content
(the existing content is overwritten).
Because replacement times depend on the type of tool bur or
workpiece as well as the cutting conditions, adjust the replace-
ment time value as necessary.
Registers an additional tool bur. You can register up to 20 tool burs.
Duplicates the selected tool bur. Enter a different name for the "Cutter name."
The "Work time" is set to "0," and the "Replacement time" is duplicated.
Deletes the tool bur selected in the list.