Roland MDX-50 User Manual page 21

B
Load the tool bur.
CAUT I ON
If you load a tool bur with a length that is longer than that which can be used by this machine, an error will
occur.
When using the included table
1 Pass the tool bur through the tool holder with the orientation shown in the following figure and
ensure that the shank part is within the range indicated with "SHANK END."
2 Load the tool bur such that it does not extend past the "TABLE" line.
Scale
This is the guide-
line for the projec-
tion of the blade.
When a rotary axis (option) has been installed
1 Pass the tool bur through the tool holder with the orientation shown in the following figure and
ensure that the shank part is within the range indicated with "SHANK END."
2 Load the tool bur such that it does not extend past the "ROTARY" line.
Scale
This is the guide-
line for the projec-
tion of the blade.
SHANK
SHANK
END
END
SHANK
END
ROTARY
60
ROTARY
TABLE
TABLE
SHANK
SHANK
END
END
ROTARY
ROTARY
60
TABLE
TABLE
Ensure that the tool
bur does not project
outside of this range.
Ensure that the tool
bur does not project
outside of this range.
3. Cutting (One Side Cutting)
3. Cutting
19