Turning Off The Status Lights During Cutting; Changing The Blower Strength During Cutting - Roland MDX-50 User Manual

Turning Off the Status Lights during Cutting

Procedure
A
Display the following screen.
1 Press [MENU] several times to display the "Set" screen.
2 Select "Lights during Cutting," and then press [ENTER].
B
Turn the hand-wheel to select "Off."
C
Press [ENTER].
M E M O
When the power is turned off, this returns to the default value ("On").

Changing the Blower Strength during Cutting

This machine is equipped with an air blower. It activates automatically during tool burr replacement to clear away the cutting
waste from the top of the magazine. You can also activate the air blower during cutting. However, the air blower is actived
during cutting, cutting waste is more likely go outside of the machine. In the following cases, set the air blower setting to "off."
・ Using the material which is powderised when you cut.
・ When the cutting waste go outside of the machine.
* When the tool bur is replaced, this setting is always set to "Strong."
Procedure
A
Display the following screen.
1
Press [MENU] several times to display the "Set" screen.
2 Select "Blower," and then press [ENTER].
B
Turn the hand-wheel to select the blower setting.
C
Press [ENTER].
5. Built-in Panel Operation (Practical Use)
Built-in Panel Functions
Blower
49