Spindle Maintenance" Dialog Box; Automatic Correction" Dialog Box - Roland MDX-50 User Manual

"Settings" Dialog Box

"Spindle maintenance" Dialog Box

- [Maintenance] tab - [Spindle maintenance]
Move
Total work time
Reset
Start

"Automatic correction" Dialog Box

- [Correction] tab - [Automatic correction]
Magazine
Rotary axis unit
A origin at reference
corner of rotary axis
unit
Start Correction
Stop
60
6. VPanel Operation (Practical Use)
Move the spindle to the replacement position.
This displays the total working time of the spindle. You cannot enter the value.
After replacing the spindle unit, click [Reset] to reset the value to 0.
Start spindle run-in. (This takes approximately 40 minutes.)
Select this check box to detect the magazine and correct its position.
Select this check box to detect the rotary axis and correct its position.
Select this check box to set the user origin to the position where the clamp
becomes level.
Start automatic correction. This button is disabled during correction.
Cancel automatic correction. This button is only enabled during correction.