Operation" Tab - Roland MDX-50 User Manual

"Operation" Tab

This machine is equipped with an air blower. It activates automatically during tool burr replacement to clear away the cutting
waste from the top of the magazine. You can also activate the air blower during cutting. However, the air blower is actived
during cutting, cutting waste is more likely go outside of the machine. In the following cases, set the air blower setting to "off."
・ Using the material which is powderised when you cut.
・ When the cutting waste go outside of the machine.
Cutting blow
If you change this setting during cutting, the new setting will be the initial value the
next time cutting is performed.
* When the tool bur is replaced, this setting is always set to "Strong."
Initial value: Off
"Settings" Dialog Box
6. VPanel Operation (Practical Use)
57