3. Cutting
WARNING
Step 1 : Preparing the Tool Bur
Required Items
Tool bur
* For attachable tool, refer to the " Setup Guide"
The tool holder to use differs depending on the shank diameter of the tool bur.
Shank diameter
mm specifications : 6 mm
inch specifications : 0.25 in.
Procedure
A
Load the tool holder in the tool positioner.
Place the tool positioner by aligning the holes as shown in the following figure.
18
3. Cutting (One Side Cutting)
Do not inadvertently touch the computer or the built-in panel while performing this
task.
Unintended operation of the machine may lead to you being caught in the machine.
Tool holder *
Mounting screw
Orient the tool
holder so that
the side with
the plastic
sheet faces up.
Plastic sheet
Tool positioner
Shank diameter
Shank diameter
mm specifications : 3, 4 mm
inch specifications : 0.125 in.
Hexagonal screw-
driver