Advertisement
M9000DT-M, WSM
[4] CHECK AND MAINTENANCE
(1) Check Points of Initial 50 Hours
(2) Check Points of Every 600 Hours
Checking Wheel Mounting Nuts Tightening Torque
CAUTION
• Never operate tractor with a loose rim, wheel, or axle.
• Any time bolts and nuts are loosened, retighten to specified
torque.
• Check all bolts and nuts frequently and keep them tight.
1. Check the wheel mounting nut regularly especially when new. If
there are loosened, tighten as follows.
Front wheel mounting nut
Front wheel rim bolt
Tightening torque
Rear wheel mounting nut
Rim clamp bolt
(1) Front Wheel Mounting Nut
(2) Front Wheel Rim Bolt
Changing Transmission Fluid
CAUTION
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. To drain the used oil, remove the drain plug (1) and (2) at the
bottom of the transmission case and drop axle case and drain the
oil completely into the oil pan.
2. After drain reinstall the drain plug (1) and (2).
3. Fill with the new KUBOTA SUPER UDT fluid up to the upper
notch on the dipstick (4). (See page MG-2.)
4. After running the engine for a few minutes, stop the engine and
check the oil level again, add oil to prescribed level.
IMPORTANT
• Do not operate the tractor immediately after changing the
transmission fluid.
• Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
Standard
Oil Capacity
With 80 in. wide axle
(1) Drain Plug
(2) Drain Plug (both side)
(3) Oil Inlet
(4) Dipstick
MG-4
G GENERAL
260 to 304 N·m
26.5 to 31.0 kgf·m
192 to 224 ft-lbs
198 to 279 N·m
20.2 to 28.4 kgf·m
146 to 205 ft-lbs
260 to 304 N·m
26.5 to 31.0 kgf·m
192 to 224 ft-lbs
305 to 373 N·m
31.1 to 38.0 kgf·m
225 to 275 ft-lbs
(3) Rim Clamp Bolt
(4) Rear Wheel Mounting Nut
W1042468
56 L
59.2 U.S.qts.
49.3 Imp.qts.
57 L
60.1 U.S.qts.
50.2 Imp.qts.
A : Oil level acceptable within this
range.
W1042893
KiSC issued 04, 2006 A
Hide quick links:
Advertisement
