Kubota M9000DT-M Workshop Manual Supplement page 33

M9000DT-M, WSM
18T Gear Shaft and 25T Idle Gear
1. Remove the external snap ring (1) and ball bearing (2).
2. Take out the 25T-23T gear (4).
3. Remove the external snap ring (17).
4. Tap out the 18T gear shaft (14) to the rear side.
5. Tap out the spring pin (19).
6. Tap out the 25T idle gear shaft (20) with gear (18).
(When reassembling)
• Apply molybdenum disulfied (Three Bond 1901 or equivalent) to
inner surface of 32T gear (16) and 37T gear (11).
• Direct the grooved side of thrust collar (13) to the gear side.
(1) External Snap Ring
(2) Bearing
(3) Collar
(4) 25T-23T Gear
(5) Needle Bearing
(6) Collar
(7) Thrust Needle Bearing
(8) Thrust Collar
(9) 23T Gear
(10) 27T Gear
Synchronizer Unit
(1) Inner Synchronizer Ring
(2) Center Ring
(3) Shifter
DT Propeller Shaft
1. Remove the external snap ring (3).
2. Pull out the propeller shaft 1 (5) to the rear side.
3. Remove the propeller shaft 2 (1) with 28T gear (2) to the
transmission case upper side.
(1) Propeller Shaft 2
(2) 28T Gear
(3) External Snap Ring
Gear Case
1. Remove the plug (5) and internal snap ring (6).
2. Remove the screw (10).
3. Tap out the shaft (8) to the front side.
4. Take out the 20T gear (1) and 31T gear (3).
(1) 20T Gear
(2) Collar
(3) 31T Gear
(4) Bearing
(5) Plug
M3-S12
TRANSMISSION
(11) 37T Gear
(12) Inner Race
(13) Thrust Collar
(14) 18T Gear Shaft
(15) Synchronizer Unit
(16) 32T Gear
(17) External Snap Ring
(18) 25T Idle Gear
(19) Spring Pin
(20) 25T Idle Gear Shaft
W1017018
(4) Synchronizer Key
(5) Synchronizer Key Spring
(6) Outer Synchronizer Ring
W1017609
(4) 24T Gear
(5) Propeller Shaft 1
W1017690
(6) Internal Snap Ring
(7) Bearing
(8) Shaft
(9) Gear Case
(10) Screw
W1017798
KiSC issued 04, 2006 A