Advertisement
M9000DT-M, WSM
Bearing Holder
1. Remove the bearing holder 1 (1) with the shaft (2) by screwing
M8 × Pitch 1.25 mm screws into holes A and B.
(When reassembling)
• Apply grease or transmission fluid to the O-ring.
Bearing holder 1 mounting
Tightening torque
screw and nut
(1) Bearing Holder 1
Front Wheel Drive Gear
1. Remove the external snap ring (3) and 33T gear (2) with collar
(4).
2. Remove the external snap ring (5) and 36T gear (6).
3. Draw out the PTO propeller shaft (1).
(1) PTO Propeller Shaft
(2) 33T Gear
(3) External Snap Ring
Disassembling Auxiliary Shift Section
1. Take out the PTO propeller shaft.
2. Remove the bearing holder 2 (15) mounting screws.
3. Remove the auxiliary shift section assembly.
(When reassembling)
• Direct the grooved side of the thrust collar (5) to the gear side.
Bearing holder 2 mounting
Tightening torque
screw
(1) External Snap Ring
(2) Shifter
(3) Hub
(4) Bearing
(5) Thrust Collar
(6) Needle Bearing
(7) Collar
(8) Needle Bearing
(9) 38T-19T Gear
(10) Thrust Collar
(11) External Snap Ring
(12) 47T Gear
(13) 15T Gear Shaft
(14) Bearing
(15) Bearing Holder 2
M3-S9
TRANSMISSION
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 ft-lbs
(2) Shaft
W1015255
(4) Collar
(5) External Snap Ring
(6) 36T Gear
W1015496
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.2 to 66.5 ft-lbs
(16) Shift Fork
(17) Needle Bearing
(18) Collar
(19) Needle Bearing
(20) 37T Gear
(21) Shaft
(22) Rod
(23) Shifter
(24) Shifter Fork
(25) Needle Bearing
(26) 51T Gear
(27) Thrust collar
(28) Internal Snap Ring
(29) Bearing
(30) Internal Snap Ring
W1015618
KiSC issued 04, 2006 A
Hide quick links:
Advertisement
