Kubota M9000DT-M Workshop Manual Supplement page 16

M9000DT-M, WSM
(B) Adjustment Front Wheel Turning Stopper Bolt
Stopper bolts adjustment (ex. LH stopper bolt)
2025 mm (79.7 in.)
Tread
2015 mm (79.5 in.)
Stopper
1665 mm (65.6 iin.)
Tread
1655 mm (65.3 in.)
Stopper
L : 12 mm (0.47 in.)
1
Take the following steps to adjust the turning angle with the
stopper.
1. Slightly tighten the stopper bolt.
2. Start the engine. Turn the steering wheel to the right and left to
get the stopper two or three times into contact with the bevel gear
case. (This is to position the stopper's contact face.)
3. Then hold the stopper with an adjustable wrench to prevent it
from getting out of position. Finally tighten the stopper bolt to the
specified torque.
IMPORTANT
• The turning angle varies depending on the presence or
absence of the front weight bumper as well as the tire size.
Adjust the stopper bolt with these factors in mind.
• Make sure that stopper bolts are always tightened to the
correct torque.
(1) Stopper Bolt
1925 mm (75.8 in.)
1910 mm (75.4 in.)
1565 mm (61.6 in.)
1550 mm (61.1 in.)
L : 3 mm (0.19 in.)
2
1830 mm (72 in.)
B : Stopper Bolt
MG-9
G GENERAL
A : Front
W1020179
KiSC issued 04, 2006 A