Kubota M9000DT-M Workshop Manual Supplement page 27

M9000DT-M, WSM
Center Frame and ROPS
1. Remove the remote valve wire.
2. Remove the draft and position control lever grips (1), (2).
3. Remove the auxiliary speed change lever grip (7).
4. Remove the DT shift lever grip (4).
5. Remove the three point hitch lowering speed control grip (8) and
PTO lever (3).
6. Remove the center frame (6).
7. Remove the ROPS (5).
(When reassembling)
ROPS mounting screw
Tightening torque
M16 grade 9 screw
(1) Position Control Lever Grip
(2) Draft Control Lever Grip
(3) PTO Lever
(4) DT Shift Lever Grip
(5) ROPS
Floor Mat and Housing Cover
1. Remove the floor mat (1).
2. Remove the housing cover (2).
(1) Floor Mat
Pedal Frame
1. Disconnect the brake rods (3) (Right and Left).
2. Disconnect the clutch rod (2).
3. Disconnect the shuttle rod (5).
4. Remove the delivery pipe (4) for PTO clutch.
5. Remove the pedal frame (1) with wire harness.
IMPORTANT
• After reassembling the pedal frame, be sure to adjust the
brake pedal travel and clutch pedal free travel.
(When reassembling)
Pedal frame mounting
Tightening torque
screw
Shuttle rod length A Factory spec.
(1) Pedal Frame
(2) Clutch Rod
(3) Brake Rod
M3-S6
TRANSMISSION
260 to 304 N·m
26.5 to 31.0 kgf·m
192 to 224 ft-lbs
(6) Center Frame
(7) Auxiliary Speed Change Lever Grip
(8) Three Point Hitch Lowering Speed
Control Grip
W1013193
(2) Housing Cover
W1013600
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
268 mm
10.55 in.
(4) Delivery Pipe
(5) Shuttle Rod
W1013695
KiSC issued 04, 2006 A