Kubota M9000DT-M Workshop Manual Supplement page 31

M9000DT-M, WSM
1st Shaft
1. Tap out the spring pin (33) from shift fork (32).
2. Remove the bolt (30), and take out the ball and spring.
3. Take out the pin (34) and ball from hole.
4. Draw out the shift rod (31) and take out the shift fork (32).
5. Remove the bearing holder 3 (35).
6. Remove the external snap ring (1).
7. Tap out the 1st shaft (13) to the rear.
8. Take out the gears.
(1) External Snap Ring
(2) Collar
(3) Bearing
(4) Synchro Holder
(5) Synchronizer Unit
(6) 26T Gear
(7) Inner Race
(8) Needle Bearing
(9) Thrust Collar
(10) Inner Race
(11) 20T Gear
(12) 15T Gear
(13) 1st Shaft
(14) 26T Gear
(15) Synchronizer Ring
(16) Shifter Assembly
(17) 30T Gear
(18) Inner Race
M3-S10
TRANSMISSION
(19) Shifter
(20) Hub
(21) Synchronizer Pin 1
(22) Synchronizer Pin 2
(23) Synchronizer Ring
(24) Inner Core
(25) Retainer
(26) Shifter
(27) Key
(28) Spring
(29) Hub
(30) Bolt
(31) Shift Rod
(32) Shift Fork
(33) Spring Pin
(34) Pin
(35) Bearing Holder 3
W1016921
KiSC issued 04, 2006 A