Advertisement
M9000DT-M, WSM
Wire Harness R.H. and Fuel Pipes
1. Disconnect the 3P connector for solenoid valve (3).
2. Disconnect the wiring lead (2) from the glow plug.
3. Disconnect the coolant thermo sensor 1P connector (1).
4. Remove the fuel pipes.
(1) Coolant Thermo Sensor 1P
Connector
(2) Wiring Lead for Glow Plug
Wire Harness L.H.
1. Disconnect the alternator 2P connector (1) and B terminal (2).
2. Disconnect the starter motor C terminal (5) and B terminal (4).
3. Disconnect the engine oil pressure switch terminal (3).
(When reassembling)
Starter's terminal B
Tightening torque
mounting nut
(1) Alternator 2P Connector
(2) Alternator B terminal
(3) Engine Oil Pressure Switch Terminal
Propeller Shaft
1. Slide the propeller shaft cover (3), (4) after removing the screws
(7), (8).
2. Tap out the spring pin (2), (6) and then slide the coupling (1), (9)
to the front and rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft (5) and pinion
shaft.
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft Cover
(4) Propeller Shaft Cover
(5) Propeller Shaft
Gear Case
1. Remove the gear case mounting screw.
2. Remove the gear case assembly.
(When reassembling)
• Apply liquid gasket (Three Bond 1216 or equivalent) to joint face
of the clutch housing and gear case.
Tightening torque
Gear case mounting screw
M3-S4
TRANSMISSION
(3) 3P Connector for Solenoid Valve
(4) Fuel Pipes
W1011919
8.8 to 11.8 N·m
0.9 to 1.2 kgf·m
6.5 to 8.7 ft-lbs
(4) Starter Motor B Terminal
(5) Starter Motor C Terminal
W1012136
(6) Spring Pin
(7) Screw
(8) Screw
(9) Coupling
W1012314
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
W1012458
KiSC issued 04, 2006 A
Hide quick links:
Advertisement
