Advertisement
M9000DT-M, WSM
(3) Treads Adjustment
(A) Front Wheel
Standard
With 80 in.
1830 mm (72 in.)
wide axle
13.6–38
Front tread width can be adjusted as shown with the standard
equipped tires.
To change the tread width
1. Remove the wheel rim and disk mounting bolts.
2. Change the position of the rim and disk (right and left) to the
desired position, and tighten the bolt.
3. Adjust the toe-in [2 to 8 mm (0.1 to 0.3 in.)].
IMPORTANT
• Always attach wheels as shown in the drawing.
• If not attached as illustrated, transmission parts may be
damaged.
• When re-fitting or adjusting a wheel, tighten the bolts to the
following torques then recheck after driving the tractor 200
m (200 yards) and thereafter according to service interval.
NOTE
• Wheels with beveled or tapered holes, use the tapered side
of lug nut.
Tightening torque
(1) Front Wheel Mounting Nut
–
1565 mm (61.6 in.)
1925 mm (75.8 in.)
A : Tread
MG-8
260 to 304 N·m
Front wheel mounting nut
26.5 to 31.0 kgf·m
192 to 224 ft-lbs
198 to 278 N·m
Front wheel rim nut
20.2 to 28.4 kgf·m
146 to 205 ft-lbs
(2) Front Wheel Rim Nut
1665 mm (65.6 in.)
2025 mm (79.7 in.)
G GENERAL
W1031994
W1031401
KiSC issued 04, 2006 A
Hide quick links:
Advertisement
