Kubota M9000DT-M Workshop Manual Supplement page 17

M9000DT-M, WSM
(C) Rear Wheels
Standard
With 80 in.
1845 mm (72.6 in.)
wide axle
13.6–38
(1) Rear Wheel Rim
(4) Auxiliary Steps
Rear tread width ranges from approximately 1525 to 2045 mm
(60 to 80 in.) and is adjustable in 100 mm (4 in.) increments.
To change the rear tread.
1. Remove the clamp mounting bolts.
2. Change the clamp position of the rim and disk to the desired
position, and tighten the bolts.
Tightening torque
(1) Rear Wheel Mounting Nut
–
(2) Rear Wheel Disc
Reposition the auxiliary steps, as required according to the tread.
Tightening torque
Auxiliary steps
(1) Handrail
(2) Auxiliary Step
(3) Bolt
MG-10
Rear wheel mounting nut
1525 mm (60.0 in.)
1940 mm (76.3 in.)
(3) Clamp
Bolt
Tread A
Tread B
G GENERAL
260 to 304 N·m
26.5 to 31.0 kgf·m
191.8 to 224.2 ft-lbs
(2) Rim Clamp Bolt
W1021223
1630 mm (64.2 in.)
2045 mm (80.6 in.)
(4) Tread
W1030296
77 to 90 N·m
7.9 to 9.2 kgf·m
57 to 67 ft-lbs
1515 to 1615 mm
59.6 to 63.6 in.
1830 to 2030 mm
72 to 80 in.
(4) Spring Washer
(5) Nut
W1044475
KiSC issued 04, 2006 A