Installation Of The Hub To The Frame - Shimano Nexus Inter-8 Dealer's Manual

„ Installation of the hub to the frame
1.
Mount the chain on the sprocket, and then set the hub axle into the
dropouts.
2.
Place the non-turn washers onto the right side and left side of the
hub axle. At this time, turn the cassette joint so that the projecting
parts of the non-turn washers fit into the grooves of the dropouts.
If this is done, the cassette joint can be installed so that it is almost
parallel to the chainstay.
• Use whichever non-turn washers match the shape
of the dropouts. Different non-turn washers are
used at the left and right sides.
• The projecting parts should be on the dropouts side.
• Install the non-turn washers so that the projecting parts is
securely in the dropouts grooves on either side of the hub axle.
Note:
When installing a part such as a mudguard stay to the hub axle,
install in the order shown in the illustration below.
Non-turn washer (for left side)
Cassette joint
Dropouts
Right
5R / Yellow
Standard
7R / Black
Reversed 6R / Silver
Reversed
5R / Yellow
(full chain case)
Vertical 8R / Blue
Note: Vertical: Excluding the coaster specifications.
14
Groove of dropout
Non-turn washer
Chainstay
(for right side)
Non-turn washer
Mark / Color
Left
5L / Brown
20° ≤ ϴ ≤ 38°
7L / Gray
6L / White
5L / Brown
ϴ = 60° – 90°
8L / Green
Mark
Non-turn washer
Washer
Mudguard stay
Carrier stay
Hub axle
Dropout
Size
ϴ ≤ 20°
ϴ = 0°
ϴ = 0°
ϴ
Cap nut