Installation Of The Hub To The Frame - Shimano Alfine S7000 Series Dealer's Manual

INSTALLATION

Installation of the hub to the frame

„ Installation of the hub to the frame
1
(A)
2
(C)
Fork ends
Standard
Reversed
Reversed
(full chain case)
Vertical
To be continued on next page
When not using the chain tensioner
Mount the chain on the sprocket, and
then set the hub axle into the fork ends.
(A) (B)
When using the chain tensioner
Mount the chain on the sprocket, and
(C)
then set the hub axle into the fork ends.
(B) (A)
Place the non-turn washers onto the
(B)
right side and left side of the hub axle.
At this time, turn the cassette joint so
that the projecting parts of the non-turn
washers fi t into the grooves of the fork
ends. If this is done, the cassette joint
can be installed so that it is almost
parallel to the chainstay.
(D) (E)
Non-turn washer
Mark / Color
Right Left
5R/Yellow 5L/Brown
7R/Black 7L/Gray
6R/Silver 6L/White
5R/Yellow 5L/Brown
8R/Blue 8L/Green
Size
ϴ ≤ 20°
20° ≤ ϴ ≤ 38°
ϴ = 0°
ϴ = 0°
ϴ = 60° – 90°
16
(A)
Hub axle
(B)
Fork ends
(C)
Chain tensioner
NOTE
When using the chain tensioner, be sure to
read these service instructions in conjunction
with the service instructions for the CT-S500
chain tensioner.
(A)
Non-turn washer (for left side)
(B)
Groove of fork end
(C)
Chainstay
(D)
Cassette joint
(E)
Non-turn washer (for right side)
TECH TIPS
•
Use whichever non-turn washers match the
shape of the fork ends. Different non-turn
washers are used at the left and right sides.
•
The projecting parts should be on the fork
ends side.
•
Install the non-turn washers so that the
projecting parts is securely in the fork ends
grooves on either side of the hub axle.
Mark
θ