Shimano Nexus Inter-8 Dealer's Manual page 20

3.
After checking that the end of the outer casing is sitting securely in the cable adjustment bolt of the REVOSHIFT lever / shifting
lever, attach the inner cable fixing bolt unit to the inner cable.
When installing the inner cable fixing bolt unit, use the setting tool TL-CJ40 (Y70898020).
For CJ-NX10 and CJ-8S20, use the front side of TL-CJ40.
Note:
The tool is shipped ready to be used for CJ-NX10 and CJ-8S20.
Note:
This inner cable fixing bolt unit is designed only for CJ-NX10, CJ-NX40, CJ-8S20, and CJ-8S40. 11-speed fixing bolt units cannot
be used.
Inner cable fixing bolt unit
10 mm
Pass the inner cable through the hole.
4.
Bring the cable around to the cassette joint pulley, hold so that the inner cable fixing nut is facing to the outside (toward the
fork end), and then slide the flats part of the inner cable fixing washer into the gap in the pulley.
Flats part of inner cable
fixing washer
Nut fitting
Inner cable fixing nut
(Black)
Inner cable fixing washer
(Silver)
Inner cable fixing bolt
(Silver)
Gap in pulley
Front side
TL-CJ40
Pull the inner cable while attaching Pull the inner cable while attaching
the inner cable fixing bolt unit. the inner cable fixing bolt unit.
Tightening torque:
3.5 - 5.5 N·m {31 - 48 in. lbs.}
20
101 mm
Inner cable fixing nut
Pulley