In The Case Of Cj-Nx40 / Cj-8S40 - Shimano Nexus Inter-8 Dealer's Manual

< In the case of CJ-NX40 / CJ-8S40 >
Disconnect the cable from the cassette joint when removing the rear
wheel from the frame.
1.
Set the REVOSHIFT lever / shifting lever to
REVOSHIFT
< REVOSHIFT Lever >
1
Set to
2.
Hold the rubber cover and pull the outer casing holder
out from the outer casing holder section of the cassette
joint. Then remove the inner cable attached to the
rubber bellows from the slit in the bracket. Be careful
not to damage the rubber bellows at this time.
Note:
Do not remove the cable by pulling the outer casing.
1
.
1
RAPIDFIRE Plus
< Shifting Lever >
Set to
Rubber bellows
Outer casing
holder section
31
Cassette joint
1 .. 4 .. 7
1
Outer casing
holder
Slit
Pull out the
outer casing holder
Rubber cover
Remove the rubber
bellows from the slit