8-Gear Hub - Shimano Nexus Inter-8 Dealer's Manual

< 8-gear hub >
Place right hand dust cap C or B onto the driver on the right side
of the hub body. Next, install the sprocket and secure it in place
with the snap ring.
Specifications
Outward
assembling
A 16T - 23T
B
Note:
• For A specifications: If the sprocket is an inward assembling
sprocket with 19T or less or for belt drive specifications, right
hand dust cap A will come into contact with the chain or pulley
and so B specifications should be used instead.
• For B specifications: If the sprocket is an inward assembling
sprocket with 16T and 3 mm teeth or for belt drive
specifications, remove right hand dust cap B before use.
Applicable sprockets
Inward
assembling
20T - 23T
16T - 23T
Snap ring
Sprocket
Driver
A specifications:
Right hand dust cap A
10
Note the
direction
A specifications:
Right hand dust cap C
B specifications:
Right hand dust cap B
B specifications:
Right hand dust cap A