Installation Of The Hub To The Frame - Shimano BR-C6000 Dealer's Manual

INSTALLATION

Installation of the hub to the frame

„ Installation of the hub to the frame
Rear side
The hub installation is an example. Also refer to the manual for the hub.
1
(C)
(E)
2
Dropouts
Standard
Reversed
Reversed
(full chain
case)
Vertical
Note: vertical: excluding the coaster specifications
To be continued on next page
(A)
(B)
(D)
(F)
(G)
Non-turn washer
Mark/Color
Right Left
5R/Yellow 5L/Brown
7R/Black 7L/Gray
6R/Silver 6L/White
5R/Yellow 5L/Brown
8R/Blue 8L/Green
Mount the chain on the sprocket, and
then set the hub axle (A) into the
dropouts (B).
Place the non-turn washers onto the
right side and left side of the hub axle.
At this time, turn the cassette joint (E)
so that the projecting parts of the non-
turn washers fit into the grooves of
the dropouts (D). If this is done, the
cassette joint can be installed so that it
is almost parallel to the chainstay (F).
Size
ϴ ≤ 20°
20° ≤ ϴ ≤ 38°
ϴ = 0°
ϴ = 0°
ϴ = 60° - 90°
12
(A)
Hub axle
(B)
Dropouts
(C)
Non-turn washer (for left side)
(D)
Grooves of the dropouts
(E)
Cassette joint
(F)
Chainstay
(G)
Non-turn washer (for right side)
NOTE
When installing a part such as a mudguard
stay to the hub axle, install in the order
shown in the illustration below.
Non-turn
washer
Mudguard stay
Carrier stay
•
Use whichever non-turn washers match
the shape of the dropouts. Different non-
turn washers are used at the left and
right sides.
•
The projecting parts should be on the
dropouts side.
•
Install the non-turn washers so that the
projecting parts is securely in the
dropouts grooves on either side of the
hub axle.
Mark
Washer
Cap nut
ϴ