Shimano Nexus Inter-8 Dealer's Manual page 28

< When bicycle is standing up >
Should be straight
Cassette joint
bracket
• If the yellow setting lines are not aligned, turn the cable adjustment bolt of the REVOSHIFT lever / shifting lever to align the
setting lines. After this, move the REVOSHIFT lever / shifting lever once more from
re-check to be sure that the yellow setting lines are aligned.
< REVOSHIFT Lever >
Cable adjustment bolt
4
3.
After adjusting the cassette joint, cut off the excess length of inner
cable and then install the inner end cap.
Cassette joint
pulley
Note
In the case of 8 gears ......... 4
In the case of 7 gears ......... 4
In the case of 5 gears ......... 3
28
< When bicycle is upside down >
Should be straight
Cassette joint
bracket
X Y
to and then back to
< Shifting Lever >
X Y
1
1
1
Cable adjustment bolt
15 – 20 mm
Cassette joint
pulley
X
, and then
1 .. 4 .. 7
Inner end cap