Installation - ACME SAM-50 User Manual

3. Description of the device
1. Quick-lock fastener
2. Omega clamp
Front panel of the fixture :
3. Power switch
4. Power cord
5. Circuit break
6. DMX input
7. DMX Output
Rear panel of fixture
8. Jog wheel
9. Enter button
10. Esc button
11. LCD display
4-

4. Installation

Overhead installation:
1. Bolt each clamp (1) (not included) to the omega holder (4) with M12 bolt and lock nut
through the hole in the holder.
2. Fasten the omega holders on the bottom of the base by inserting both quick-lock
fasteners (3) into the holes of the base and tighten fully clockwise.
3. Fasten the safety cable (2) through the two apertures on the bottom of the base and
over the trussing system.
5-