VACON · 194
Table 61: Fault codes
Fault
Fault ID
code
9
80
81
10
91
11
100
13
120
121
14
130
131
132
133
15
140
16
150
17
160
11
Fault name
Possible cause
Undervoltage (fault)
The DC-link voltage is lower
than the limits.
Undervoltage (alarm)
•
•
•
•
NOTE!
This fault becomes active
only if the drive is in Run
state.
Input phase
The input line phase is
missing.
Output phase super-
The measurement of cur-
vision
rent tells that there is no
current in 1 motor phase.
AC drive undertem-
Too low a temperature in
perature (fault)
the heatsink of the power
unit or in the power board.
AC drive undertem-
The heatsink temperature is
perature (alarm)
less than -10 °C.
AC drive overtemper-
Too high a temperature in
ature (fault, heatsink)
the heatsink of the power
unit or in the power board.
AC drive overtemper-
The heatsink temperature is
ature (alarm, heat-
more than 100 °C.
sink)
AC drive overtemper-
ature (fault, board)
AC drive overtemper-
ature (alarm, board)
Motor stalled
The motor stalled.
Motor overtempera-
There is too heavy a load on
ture
the motor.
Motor underload
There is not a sufficient load
on the motor.
How to correct the fault
If there is a temporary supply volt-
age break, reset the fault and
restart the drive.
Do a check of the supply voltage. If
too low a supply volt-
the supply voltage is sufficient,
age
there is an internal fault.
AC drive internal fault
Ask instructions from the distribu-
a defective input fuse
tor near to you.
the external charge
switch is not closed
Do a check of the supply voltage,
the fuses and supply cable.
Do a check of the motor cable and
the motor.
Do a check of the actual quantity
and flow of cooling air.
Examine the heatsink for dust.
Do a check of the ambient temper-
ature.
Make sure that the switching fre-
quency is not too high in relation to
the ambient temperature and the
motor load.
Do a check of the motor and the
load.
Decrease the motor load. If there is
no motor overload, do a check of
the temperature model parame-
ters.
Do a check of the load.
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205
FAULT TRACING