Vacon 100 hvac Applications Manual page 146

VACON · 146
Selection
number
Test 0% (Not used)
0
TEST 100%
1
Output frequency
2
Frequency reference
3
4 Motor speed
Output current
5
Motor torque
6
Motor power
7
8 Motor voltage
9 DC-link voltage
10 PID1 output
11 PID2 output
12 Process Data In 1
13 Process Data In 2
14 Process Data In 3
15 Process Data In 4
16 Process Data In 5
17 Process Data In 6
18 Process Data In 7
19 Process Data In 8
NOTE!
For ProcessDataIn, use value without a decimal separator, for example, 5000
=50.00%.
P3.5.4.1.2 AO1 FILTER TIME (ID 10051)
Use this parameter to set the filtering time for the analog signal.
10
Selection name
The analogue output is set to 0% or 20% so that it agrees
with parameter P3.5.4.1.3.
The analogue output is set to 100% of the signal (10V /
20mA).
The actual output frequency from 0 to Maximum frequency
reference.
The actual frequency reference from 0 to Maximum fre-
quency reference.
The actual motor speed from 0 to Motor nominal speed.
The output current of the drive from 0 to Motor nominal cur-
rent.
The actual motor torque from 0 to motor nominal torque
(100%).
The actual motor power from 0 to Motor nominal power
(100%).
The actual motor voltage from 0 to Motor nominal voltage.
The actual DC-link voltage 0...1000V.
The output of the PID controller 1 (0...100%).
The PID controller 2 output (0...100%).
Process Data In 1: 0...10000 (this agrees with 0...100.00%).
Process Data In 2: 0...10000 (this agrees with 0...100.00%).
Process Data In 3: 0...10000 (this agrees with 0...100.00%).
Process Data In 4: 0...10000 (this agrees with 0...100.00%).
Process Data In 5: 0...10000 (this agrees with 0...100.00%).
Process Data In 6: 0...10000 (this agrees with 0...100.00%).
Process Data In 7: 0...10000 (this agrees with 0...100.00%).
Process Data In 8: 0...10000 (this agrees with 0...100.00%).
PARAMETER DESCRIPTIONS
Description
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205